Контроллер программируемый SIEMENS 6ES7522-5FF00-0AB0

Alarms
Diagnostic alarm	No

Ambient temperature during operation
horizontal installation, max	60C

Ambient temperature during operation
horizontal installation, min	0C
vertical installation, min	0C

Ambient temperature during operation
vertical installation, max	40C

built-in fuse
Controlling a digital input
Size of motor starters according to NEMA, max	5

Cable length
shielded, max	1000m
unshielded, max	600m

Diagnoses
Short-circuit	No

Diagnoses
Monitoring the supply voltage	No

Diagnoses
Wire-break	No

Diagnostics indication LED
for channel diagnostics	No
Monitoring of the supply voltage (PWR-LED)	No
RUN LED	Yes; green LED

Diagnostics indication LED
Channel status display	Yes; green LED
for module diagnostics	Yes; red LED

Diagnostics indication LED
MAINT LED

Diagnostics indication LED
ERROR LED	Yes; red LED

Digital outputs
Short-circuit protection	No

Digital outputs
Current-sinking
Current-sourcing	Yes
Digital outputs, parameterizable	Yes

Digital outputs
Number of digital outputs	8
Type of digital output	Triac

Dimensions
Depth	129mm
Height	147mm
Width	35mm

Engineering with
PROFIBUS from GSD version/GSD revision	V1.0 / V5.1
PROFINET from GSD version/GSD revision	V2.3 / -
STEP 7 configurable/integrated from version	V5.5 SP3 / -

Engineering with
STEP 7 TIA Portal configurable/integrated from version	V12 / V12

General information
FW update possible	Yes

General information
Firmware version	V2.2.0
HW functional status	From FS01
Product type designation	DQ 8x230 V AC/2A ST (triac)

Highest safety class achievable for safety-related tripping of s
Category according to ISO 13849-1
Performance level according to ISO 13849-1

Input current
Current consumption, max

Interrupts/diagnostics/status information
Substitute values connectable	Yes

Interrupts/diagnostics/status information
Diagnostics function	No

Isolation
Isolation tested with	3 100 V DC

Operating mode
DQ	Yes
DQ with energy-saving function	No
Integrated operating cycle counter	Yes; FW V2.2.0 or higher
MSO	Yes
Oversampling	No
PWM	No

Output current
for signal "1" permissible range, max	15A; max. 1 AC cycle

Output current
for signal "1" rated value	2A

Output current
for signal "0" residual current, max	2mA

Output current
for signal "1" permissible range, min	10mA

output voltage / header
Rated value (AC)	230V; 120/230 V AC, 50/60 Hz

Parallel switching of two outputs
for uprating	No

Parallel switching of two outputs
for logic links	No
for redundant control of a load	Yes

Permissible potential difference
between different circuits	250 V AC between the channels and the backplane bus; 500 V AC between the channels

Potential separation channels
between the channels	Yes
between the channels and backplane bus	Yes
Between the channels and load voltage L+
between the channels, in groups of	1

Power
Power available from the backplane bus	0.9W

Power loss
Power loss, typ	10.8W

Product function
Isochronous mode	No

Product function
Prioritized startup	Yes

Product function
I&M data	Yes; I&M0 to I&M3

Relay outputs
Rated supply voltage of relay coil L+ (DC)

Relay outputs
Number of operating cycles, max
Number of relay outputs

Relay outputs
Contact connection (internal)
Current consumption of relays (coil current of all relays), typ
external protection for relay outputs
Relay approved acc. to UL 508

Standards, approvals, certificates
Suitable for safety functions	No
Suitable for safety-related tripping of standard modules

Supply voltage
Reverse polarity protection

Supply voltage
permissible range, lower limit (DC)
permissible range, upper limit (DC)
Rated value (DC)

Switching capacity of contacts
with inductive load, max
with resistive load, max

Switching frequency
on lamp load, max	1Hz

Switching frequency
with inductive load, max	0.5Hz
with resistive load, max	10Hz

Total current of the outputs
Current per channel, max	2A; see additional description in the manual
Current per group, max	2A; see additional description in the manual
Current per module, max	10A; see additional description in the manual

Weights
Weight, approx	290g

with resistive load, max
Fluorescent tubes, conventionally compensated
Fluorescent tubes, uncompensated
Low energy/fluorescent lamps with electronic control gear
on lamp load, max	50W